Oldsmobile 442 (diecast 1:18, ACME)
- Oldsmobile 442 (from 1970)
- ACME
- 1:18
- Showcase model / No engine
- diecast
- red
- In near mint condition
- Original packaging exists
- Not for sale
Limited to 996 pieces
The Oldsmobile 442 was the answer to the Pontiac GTO.
A typical American sedan from the 1970s. Large, heavy and very generous motorized ....
The number "442" refers to: 4-speed carburetor, 4 speed, 2 exhaust tailpipes.
The model with a 7.5. Liter V8 engine with 16 valves and an output of (officially) 375 hp. However, it is believed that the actual PS number was up to 410.
Thus the vehicle, which was over 5m long and nearly 2m wide, weighing 1700kg, was very well on the road.
The model:
ACME / GMP has done a very good job here. Very small gap mass, a perfect varnishing and numerous details convey a wonderful overall impression.
The model is limited to 996 pieces.
Author: Oldtimer
No responsibility is taken for the correctness of this information
A typical American sedan from the 1970s. Large, heavy and very generous motorized ....
The number "442" refers to: 4-speed carburetor, 4 speed, 2 exhaust tailpipes.
The model with a 7.5. Liter V8 engine with 16 valves and an output of (officially) 375 hp. However, it is believed that the actual PS number was up to 410.
Thus the vehicle, which was over 5m long and nearly 2m wide, weighing 1700kg, was very well on the road.
The model:
ACME / GMP has done a very good job here. Very small gap mass, a perfect varnishing and numerous details convey a wonderful overall impression.
The model is limited to 996 pieces.
Author: Oldtimer
No responsibility is taken for the correctness of this information
1102 Visitors since 10/03/2016
Comment
(0)
- Write a first comment about this model now!Any comment can be discussed by all members. It's like a chat.Mention other Modelly members by using @ in your message. They will then be informed automatically.
- Write a first comment about this model now!Any comment can be discussed by all members. It's like a chat.Mention other Modelly members by using @ in your message. They will then be informed automatically.